Opticon LMD 1135 - Manual (Page 44)

Manual No. 25-ULPNR102-01; Mar, 2005 LMD 1135 Laser Fixed Mount Scanner
Page 40
For example, if a Code 39 label of length 2 characters were scanned in Step 3 then only Code 39 labels
would be checked for a minimum length of 2 characters. If a second label had been read in Step 3
(immediately following the first), then that particular symbology could have been set to different
minimum character length.
In a similar manner, the maximum length for selected codes can be established by using the “Enable
maximum length for selected codes” (HM) command.
14. Creating a Prefix and/or Suffix
Computer
Command
Function
/Description
Bar Code
Command
(ZZ)
START/END
Programming Menu
[[
Z3
Display Settings including
Prefix/Suffix value and length
(expressed in hexidecimal
format)
[!
The Z3 command can be used to instruct the scanner to provide a list of its current software settings
including prefixes and suffixes.
The scanner can be programmed to transmit a prefix and/or suffix with the decoded data. A Prefix (or a
Suffix) is composed of up to 4 characters. The following steps are used to establish a Prefix that will be
transmitted with the bar code data:
1. Scan Start
2. Scan the bar code representing the symbology to which you wish to add a Prefix
3. Scan the character(s) that will comprise the Prefix. Up to four numeric, alpha or control character(s)
may be used.
4. Scan “STOP” to exit the Programming Mode.
Example : To add the alpha character “A” as a Prefix and “B” as a
Suffix to UPC-A bar code data:
1. Scan “START/END Programming Mode”
2. Scan N1, representing a Prefix for UPC-A
3. Scan 0A, representing the alpha character “A”
4. Scan N6, representing a Suffix for UPC-A
5. Scan 0B, representing the alpha character “B”
6. Scan “START/END Programming Mode”