Opticon LMD 1135 - Manual (Page 19)

Manual No. 25-ULPNR102-01; Mar, 2005 LMD 1135 Laser Fixed Mount Scanner
Page 15
Section 6
Scanner Labeling
IEC 825-1 Class 1 Laser Device
The LMD 1135 has been examined and found to be a Class 1 Laser Device according to the relevant
requirements of IEC 825-1 and corresponding EN 60825-1 (1993-11) including amendment 1 (1997-09)
and amendment 2 (2001-01).
This scanner also complies with Center for Devices and Radiological Health (CDRH) 21 CFR 1040.10 and
1040.11 except for deviations pursuant to Laser Notice No. 50 dated July 26, 2001.
The LMD 1135 scanner use a low-power visible laser. As with any very bright light source, such as the
sun, you should avoid staring into the light beam. Momentary exposure to an IEC 825-1 Class 1 laser is
not known to be harmful.
A manufacturer’s label, as shown below, indicating the manufacturer, product model, ordering number,
serial number, laser class, CE mark and place of manufacture is affixed to each scanner.
Section 7
Scanner Servicing and Maintenance
CAUTION: Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous laser light exposure.
The LMD 1135 scanner contains no user adjustable or serviceable parts in the interior of the scanner. All
product service must be performed by the Opticon Service Department in Orangeburg, NY. Opening the
scanner will void the warranty and could expose the operator to laser light.
The LMD 1135 is warranted for 1 year including parts and workmanship. If you need warranty or out-of-
warranty repair, first call 1-800-636-0090 to obtain a Returned Material Authorization (RMA)
number. You will be provided a number and shipping instructions.
There is no scheduled maintenance required for the LMD 1135. The scanner can be cleaned using a
water dampened, lint free or lens cloth. Be careful to avoid excessive moisture that would penetrate the
housing or obscure the window. While use of cleaning fluids other than water are not recommended, a
neutral detergent or ethanol would be preferred if necessary. Do not use bleach at full or diluted
strength as damage to the painted case and/or window may result.