Outback Power Systems Hitch DOM-OBK03 - Manual (Page 9)

GPS IM
PLEMENT GUIDAN CE
®
7
3. Mounting the Hitch: Using a forklift, floor jack, or
chain hoist, position the Outback® Hitch under the tractor
drawbar as shown. Notice that the hydraulic hoses to the
left cylinder must route over the top of the tractor drawbar.
Center the hitch directly under the tractor drawbar with the
drawpin hole lined up over the center of the corresponding
hitch mounting hole.
4. Install Hammerstrap at Front of Hitch: Insert
mounting bolt (A) into the front slot of the hitch, on both
sides of the drawbar, and install hammerstrap plate (E).
Secure with lock washers (C) and hex nuts (D). Do not
tighten hardware at this time. Slight adjustments of the
hitch forward or backward may be required to install
mounting hardware at the rear of the hitch.
5. Remove Hitch Shipping Pallet: The hitch is secured
to the shipping pallet with two lag screws and washers.
Remove both screws and lower the shipping pallet, allow-
ing the hitch to be suspended from the front hammerstrap.
6. Connect Hydraulic Feed Hoses: The hitch hydraulic
supply lines have colored grips. Connect the supply lines
to the tractor remote outlets so that the red grip is pressure
and the black grip is return. During operation the hitch
requires a fixed 1.5 gpm oil flow, up to 3000 psi. Adjust
the tractor remote outlet oil flow to closely match this
requirement.
E
A
C D
REMOVE