Outback Power Systems Hitch DOM-OBK03 - Manual (Page 8)

GPS IM
PLEMENT GUIDAN CE
®
6
INSTALLATION
1. Tractor Preparation: Before attempting to install the
Outback® Hitch, park the tractor on a smooth level floor
with adequate clearance to work around the drawbar area.
Remove any accessories installed on the tractor drawbar
including the hammerstrap clevis and safety chain holder.
If the tractor is equipped with a drop-style drawbar, remove
the drawbar and flip it upside down. Reinstall the drawbar
as shown. The Outback® Hitch requires a minimum
mounting clearance of 14-1/4 in. (362mm) between the
center of the drawpin hole and the rear of the tractor sup-
port casting.
2. Determine Proper Mounting Configuration: The
Outback® Hitch is supplied with a universal mounting kit
(packaged in a burlap bag) and includes all necessary hard-
ware to mount the hitch to most CAT II or III tractor draw-
bars. Not all parts included in the kit are required for each
specific installation.
Carefully review the mounting hardware details shown on
page A7 for your tractor specific mounting configuration.
Identify the required parts as shown.
Label Description Qty
A 3/4” x 4” Hex Bolt, Gr5 5
B 3/4” x 6” Hex Bolt, Gr5 5
C 3/4” Lock Washer 5
D 3/4” Hex Nut, Gr5 5
E Hitch Hammer Strap Plate 1
F Hitch Spacer Plates:
3/4” Thick 3
1/2” Thick 4
1/4” Thick 2
G Draw Pin Bushings:
1-5/8”OD x 3/4”ID x 1-15/16”Lg 1
1-1/2”OD x 3/4”ID x 1-11/16”Lg 1
1-1/4”OD x 3/4”ID x 1-7/16”Lg 1
H CAT II Draw Bar Bushing:
1-3/8”OD x 13/16”ID x 1-7/16”Lg 4
14-1/4” (362mm) Min.
A B
E
F C
D
H
G