Outback Power Systems Hitch DOM-OBK03 - Manual (Page 14)

GPS IM
PLEMENT GUIDAN CE
®
12
GET ACQUAINTED WITH THE CONTROLS
RUN/HOLD
CENTER
LEFT/RIGHT ARROWS
MODE
S PRESENT
INDICATOR
HITCH POSITION
INDICATORS
HITCH POSITION INDICATORS: A series of 21 lights
indicate the current hitch pin position relative to the center
of the tractor. Each light represents approximately one
inch of hitch pin offset.
S PRESENT INDICATOR: This light indicates the pres-
ence of the Outback® S along with its GPS operational sta-
tus. If the light is off, communication with the S cannot be
established. A blinking light indicates that the S cannot
establish DGPS. A solid green light must be present to
provide automatic hitch control.
MODE: Press the MODE button to change the current
hitch operating mode. Indicator lights show the current
mode as either Follow GPS, Match Tracks, or Manual.
LEFT/RIGHT ARROWS: Press the Left or Right Arrow
buttons to manually position the hitch pin position. The
arrow buttons are also used in Match Tracks mode to adjust
the amount of compensation necessary to match the imple-
ment tracks to the tractor. The light between the arrows
indicates when the left and right arrow buttons are active.
RUN/HOLD: Pressing these buttons enables or disables
the active hitch position control. The RUN button enables
the active hitch control in the selected mode, whereas the
HOLD button suspends active control of the hitch position.
Note: As a safety feature, the tractor must be travel-
ing faster than one mile per hour before the RUN but-
ton can enable active hitch control.
CENTER: Press the CENTER Button to easily move the
hitch pin to center position and quickly prepare for road
travel. This CENTER feature may be initiated at any time
in all operating modes. A single press of the CENTER but-
ton automatically centers the hitch pin, puts the operating
mode in manual, and puts the status in hold.