Outback Power Systems Hitch DOM-OBK03 - Manual (Page 11)

GPS IM
PLEMENT GUIDAN CE
®
9
11. Determine Tilt Sensor Location: The tilt sensor
should be mounted directly onto the rear tractor frame in
an area protected from mud and flying debris. The sensor
must be oriented relative to the forward travel direction as
shown on the sensor decal. Orient the sensor with the label
up and the connector towards the rear. The sensor may
require re-orientation onto the sensor bracket to accommo-
date mounting directly to the tractor frame.
12. Mounting the Tilt Sensor: The preferred tilt sensor
mounting technique is to locate an extra bolt hole in the
rear tractor casting. The large slot on the sensor mounting
bracket can be slipped under the head of a mounting bolt
(customer supplied) and tightened. Make certain that the
sensor is oriented with the label up, level with the tractor,
and with the connector towards the rear.
13. Routing the Hitch Contol Cable: Route the hitch
control cable up from the drawbar past the tilt sensor and
through the back window of the tractor cab. Install the tilt
sensor cable connection. Secure the control cable with the
tie straps provided. Make certain that the control cable is
clear of any pinch points around the three-point linkage
and is protected from mud and flying debris.