Olympus PT-027 - Manual (Page 17)

E-16
Removing the hot shoe cable cap
When using this case in TTL flash shooting, the hot shoe cable
provided with the separately available PFL-01 should be connected
between the connector on the case and the camera’s hot shoe.
Turn the hot shoe cable connector cap inside
the case counterclockwise to remove it.
Insert the connector of the hot shoe cable into
the case's connector and turn the connector
screws all the way clockwise to connect them
firmly.
Insert the hot shoe on the hot shoe cable into
the hot shoe on the camera.
When not using the hot shoe cable, attach the
hot shoe cable cap to the hot shoe cable
connector inside the case and turn the cap all
the way clockwise to attach it firmly.
: • Be sure to remove the camera from the case when
inserting the connector of the hot shoe cable into the
case’s connector.
CAUTION
1
2
3
4
Cleaning the TTL connector
If the threaded sections of the TTL cable and TTL cable connector
stick to each other, the cable may disconnect from the connector. To
prevent this, apply O-ring silicon grease (provided with this case) to
the threaded sections.
For details, see the maintenance description on page E-35 of this
manual.
: • If you cannot disconnect the TTL cable, do not use
force to disconnect it. Contact Olympus for support.
CAUTION