beautypg.com

Ab c, Each group contains ten channels, Preset → tuning → character – Onkyo T-4711 User Manual

Page 11

background image

11

7. When the flashing channel is not the desired channel, turn the

PRESET/TUNING dial and select a different channel.

If a station frequency has already been memorized in the
selected channel, the channel number will flash quickly.

Each group contains ten channels.

The channel can also be entered using the number buttons on the
remote control. If this is done, skip step 8.

8. Press the MEMORY button.

NOTE:

40 channels are available for storing preset stations.

1. Press the PRESET/TUNING button until Preset Mode is

selected.
With each press of the button, the mode changes one at a time in
the following sequence:

Continue pressing the PRESET/TUNING button until “PRESET”
appears on the display.
Skip this step if the remote control is used.

2. Use the GROUP button to select a group (A ~ D).
3. Use the PRESET/TUNING dial to select the desired channel.

To select a preset station using the remote control:
Press the PRESET
a/b buttons.

To cancel a preset station:
1. Select the preset station as explained in the previous section.
2. While holding the MEMORY button, press the MODE button.

“--” will be shown on the MEMORY channel display.

1. Press the GROUP button, then select the group that you wish to

scan.

2. Press the SCAN button.

The stations in the preset channels are played one after another
for a few seconds each. Once you have found a station that you
wish to continue listening to, press the SCAN button again to
stop scanning.

If only one station has been stored in the selected group, the
channels are not scanned.

The part of the display that is lit up changes with each press of the
DIMMER button in the following sequence: Entire display lights up

Section [a] goes off

Section [b] also goes off

Entire display

goes off

Entire display lights up...

If the DIMMER button is pressed in stand-by mode:
In stand-by mode, each press of the DIMMER button changes the
time display to one of the four brightness levels.

Selecting a preset station

Scanning through the preset channels
(Preset Scan Tuning)

Using the DIMMER button

A

SIGNAL STRENGTH

ANTENNA

TUNED

STEREO

NARROW

HI-BLEND

AUTO

MEMORY

PRESET

PRESET / TUNING

or

Remote control

A

SIGNAL STRENGTH

ANTENNA

TUNED

STEREO

NARROW

HI-BLEND

AUTO

MEMORY

DIMMER

MEMORY

MODE

MEMORY

Remote control

or

7

8

PRESET

PRESET / TUNING

or

Remote control

A

SIGNAL STRENGTH

ANTENNA

TUNED

STEREO

NARROW

PRESET/

TUNING

DISPLAY

GROUP

SCAN

GROUP

or

Remote control

DIMMER

MEMORY

MODE

1

2

3

PRESET

TUNING

CHARACTER

SCAN

PLAY

GROUP

SCAN

Remote control

or

GROUP

DISPLAY

GROUP

SCAN

or

Remote control

1

2

TIMER
W.DAY
W.END
ONCE
SLEEP

A

B

TP

TA

SIGNAL STRENGTH

ANTENNA

RDS

TUNED

STEREO

MONO

NORMAL

NARROW

HI-BLEND

AUTO

FINE MEMORY

MEMORY

MODE

CLEAR

DIMMER

a

b

c

DIMMER

or

Remote control