Radio Shack ET-1102 - Manual (Page 9)

9
4. Insert the supplied AC adapter’s
barrel plug into the DC IN 9V jack on
the back of the base.
5. Route the modular and adapter
cords through the grooves on the
bottom of the bracket.
6. Align the keyhole slots with the
mounting screws, and slide the base
downward to secure it.
7. Plug the modular cord into a modu-
lar phone line jack.
8. Plug the adapter into a standard AC
outlet.
9. Press and lift out the handset hold-
er, rotate it 180 × , then snap it back
into place so it holds the handset.
10. Lift the base’s antenna to a vertical
position.
CONNECTING AND
CHARGING THE BATTERY
PACK
The ET-1102 comes with a recharge-
able nickel-cadmium battery pack in the
handset but not connected. Before using
your phone, you must connect the bat-
tery pack, then charge it for about 24
hours.
Grooves
43-1102.fm Page 9 Tuesday, August 17, 1999 4:37 PM