Radio Shack ET-1102 - Manual (Page 10)

10
1. Press down and slide off the battery
pack compartment cover as shown.
2. Unfasten the plastic retainer strap
and lift the battery pack out of the
compartment.
3. Plug the battery pack’s connector in-
to the socket in the compartment
(the connector fits only one way),
then replace the battery pack and
fasten the retainer strap.
4. Replace the cover.
To charge the battery pack, place the
handset either faceup or facedown on
the base. The CHARGE indicator on the
base lights and
Total:00 appears on
the handset display.
Recharge the battery pack when Low
Battery flashes on the display.
CHARGE Indicator
Important: Be sure the battery pack is
properly connected before you try to
charge it. The CHARGE indicator lights
when the handset is on the base, even if
the battery pack is not connected.
Notes:
• When you first use the phone after
charging or recharging the battery
pack, the phone might not work and
you might hear an error tone when
you press
TALK . If this happens, re-
turn the handset to the base for
about 5 seconds. This resets the se-
curity access-protection code.
• If the base loses power for 30 min-
utes while the handset is away from
it, the security access-protection
code might be lost. To reset the
code, return the handset to the base
for about 5 seconds.
The handset does not lose its secu-
rity access-protection code even if
the battery pack is completely dis-
charged.
• Using a pencil eraser, clean the
charging contacts on the handset
and the base about once a month.
43-1102.fm Page 10 Tuesday, August 17, 1999 4:37 PM