Radio Shack ET-1102 - Manual (Page 15)

15
USING FLASH
FLASH performs the electronic equiva-
lent of a switchhook operation for spe-
cial services, such as Call Waiting.
For example, if you have Call Waiting,
press
FLASH to answer an incoming call
without disconnecting the current call.
Press
FLASH again to return to the first
call.
Note: If you do not have any special
phone services, pressing
FLASH might
disconnect the current call.
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-
by-phone, require tone signals. If you
have pulse dialing, you can still use
these special tone services by following
these steps.
1. Be sure DIAL MODE is set to P .
2. Dial the service’s main number.
3. When the service answers, press
TONE ( ). Any additional numbers
you dial are sent as tone signals.
4. To reset the phone to pulse dialing,
simply hang up or press FLASH (see
“Using FLASH” on Page 15).
PAGING
To page the person who has the hand-
set or to locate the handset when the
phone is not in use, press
PAGE/FIND .
The handset beeps for 2 seconds.
To have the handset beep for a full
minute, hold down
PAGE/FIND for 2 sec-
onds. To stop the beeping sooner, press
TALK twice.
43-1102.fm Page 15 Tuesday, August 17, 1999 4:37 PM