Radio Shack ET-1102 - Manual (Page 17)

17
• If you make a mistake, move the
cursor over the error, then enter
the correct character, or press
DELETE to delete a character. To
delete all the characters, hold
down
DELETE for at least 1 sec-
ond.
6. Press SELECT . Store Number ap-
pears.
7. Enter the phone number and any
tone or pause entries (see “Using
Tone Services on a Pulse Line” on
Page 15 and “Entering a Pause” on
Page 18).
Instead of using the lower keypad
keys, you can use t or s to enter the
number and other entries and
or
to move the cursor. Repeatedly
press t to see the numbers first, then
special characters, including hy-
phens, pause entries (
P ), and tone
entries ( ). Press s to see them in
reverse order.
8. Press SELECT . The phone beeps
and Memory n Stored appears.
After 2 seconds, Memory Store
appears, and you can repeat Steps
3–8 to store more numbers.
9. When you finish, press MEM to exit
the Memory Store display.
For each stored number, write the per-
son’s or company’s name next to the ap-
propriate location number on the
supplied memory directory sticker. (Use
a pencil in case you need to change the
number later.) Peel the backing from the
sticker and attach it to the phone as
shown.
To replace a stored number, simply store
a new one in its place.
Editing or Deleting a Number in
Memory
Follow these steps to edit or delete a
memory number.
1. Lift the handset.
2. Hold down MEM until Memory
Store and a list of memory loca-
tion numbers appear on the display.
3. Choose a memory location (0–9) by
pressing a number or by repeatedly
pressing s or t.
43-1102.fm Page 17 Tuesday, August 17, 1999 4:37 PM