Radio Shack ET-2101 - Manual (Page 13)

13 Preparation
ATTACHING THE HEADSET
HOLDER
Insert the tabs on the headset holder into
the slots on the back of the base and
snap the holder into place.
CONNECTING AND
ADJUSTING THE HEADSET
1. Insert the headset’s plug
into the jack on the side of
the base.
2. Place the headset on your
head with the earpiece
over either ear.
3. Adjust the headset band
until it rests with almost no
pressure on your ear and
the top of your head.
If the headset is loose, press in slightly to tighten it. If it is
tight, gently pull the headset band out to loosen it.
4. Hold the headset in place and adjust the microphone boom
until it is about even with (but not in front of) your mouth.
Experiment until you find the most comfortable position.
Caution: The microphone boom swivels on the headset. Do not
bend the microphone boom while you adjust it.
Handset
Holder
RINGER ON/
OFF
Microphone
Boom
Headset Jack
43-2101.fm Page 13 Wednesday, February 23, 2000 9:12 AM