RCA Scenium HD65W20 - Manual (Page 32)

Basic TV Operation
28 Chapter 3
TV
AUX DVD DIRECTV
FETCH GO BACK
V
O
L V
O L
SKIP MUTE
INFO
MENU
OK
CLEAR
GUIDE
VCR1
VCR2
ON • OFF
CH +
CH -
TV
AUX DVD DIRECTV
FETCH GO BACK
V O
L V O
L
SKIP MUTE
INFO
MENU
OK
CLEAR
GUIDE
VCR1
VCR2
ON • OFF
CH +
CH -
Changing Between DIRECTV and TV Mode
When you change channels by entering numbers with the remote control, you tune to
programming that can come from one of three different sources: the DIRECTV satellite (if
you have DIRECTV
® service), a terrestrial off-air antenna, or cable TV. You tune to one of
these sources by pressing either TV or DIRECTV on the remote control; then you can enter
the channel numbers. The diagrams below show how your remote control communicates
with the three sources.
In TV mode, you tune to channels that carry
the terrestrial off-air or cable TV signal.
• To tune to an analog channel, enter
channel numbers that are up to three digits
long. Press OK to tune.
• To tune to a digital channel, enter channel
numbers that are one, two, or three digits
long. If necessary, press the right arrow
and enter a subchannel number. These
subchannel numbers appear in the box to
the right of the primary channel number.
Press OK to tune.
In DIRECTV mode, you tune to channels that
come from the DIRECTV satellite signal (if you
subscribe to DIRECTV
® programming). Enter
channel numbers that are one to four digits
long. Then press OK to tune.
Primary
Channel Subchannel
(if
necessary)
Right arrow
button