Roland FJ-42 - Manual (Page 63)

61
4 User's Reference
Printed lines are misaligned
[Example]
If misalignment like in the example occurs when the printing direction for [PRINT QUALITY] has been set to [BI-DIRECTION]
(bidirectional), then carry out correction at the [BIDIRECTION] menu (see "2-6 Printing - Making Corrections for Printing - Bidirec-
tional Correction").
Be sure to make this adjustment when you have replaced the material with a different type or adjusted the head height.
The material cannot be separated
Is a blade installed in the separating knife?
If no blade is installed, then install one (see "3-5 How to Replace the Separating Knife").
Is the blade dull or broken?
If the blade has become dull or broken, replace it with the replacement blade included with the unit (see "3-5 How to Replace the
Separating Knife").
* Some materials cannot be separated due to their composition.
The material cannot be separated automatically
Has the [AUTO SHEET CUT] menu item been set to [ENABLE]?
If the material-cutting command has been set to "enable" with the driver, then set [AUTO SHEET CUT] on the FJ-52/42 to [ENABLE]
(see "2-7 Ending Printing Operations -- Separating the Printed Portion").
Has the material-cutting command been set to "enable" with the driver?
When the material-cutting command has not been set to "enable" with the driver, automatic separation of the material is not performed,
even when [AUTO SHEET CUT] has been set to [ENABLE].
OK: Correct Not OK: Single lines not produced