Roland FJ-42 - Manual (Page 14)

12
1 Introduction
1-3 Setting Up and Connection
Setting up
For an explanation of how to assemble the unit and the stand (PNS-52/42), refer to the “ASSEMBLY INSTRUCTIONS” included with
the stand.
When using the unit while mounted on a stand, be sure to ensure a sufficient amount of installation space for the unit. The required
installation spaces for each model are listed below.
FJ-52: 2247 mm (88-1/2 in.) wide, 736 mm (29 in.) depth, and 1251 mm (49-5/16 in.) high
FJ-42: 2022 mm (79-5/8 in.) wide, 736 mm (29 in.) depth, and 1251 mm (49-5/16 in.) high
Be sure to install the drain bottle before switching on the power.
Never install the unit in any of the following situations, as it could result in breakdown or faulty operation:
Places where the installation surface is unstable or not level.
Places with excessive electrical noise.
Places with excessive humidity or dust.
Places with poor ventilation, because the FJ-52/42 generates considerable heat during operation.
Places with excessive vibration.
Places exposed to strong illumination or direct sunlight.
Unpacking, installation, and moving
must be carried out by two or more
persons.
Failure to do so
may result in
falling of the
unit, leading to
injury.
Install in a level and stable location.
Otherwise the unit may tip over and cause
injury.
NOTICE
Never step or stand on the stand legs, as doing so may damage them.
Do not place objects on the unit, as doing so may result in breakdown.