Roland FJ-42 - Manual (Page 58)

56
4 User's Reference
Default
value
Setting
range
Function Submenu
Top
menu
OVER
PRINT
NONE You can carry out the same printing superimposed over the same
location. When printing materials such as fabric, colors may not come
out well with just a single printing pass.
This should normally be set to [NONE].
For more information, see "2-9 Other Functions -- Performing Over-
printing." — NONE/2/3
SLEEP 15 min This sets the time that elapses before the unit enters the SLEEP mode.
The SLEEP mode is enabled when the FJ-52/42 has been inactive for a
specified time. (When in the SLEEP mode, the POWER LED flashes
once per second.)
To release the SLEEP mode...
- Touch any key on the control panel. - Send data from the computer.
- Open the front cover. - Move the sheet loading lever toward the back of the unit. — NONE/15
min to
120 min
(In steps of
15 min)
AUTO
SHEET CUT
— ENABLE/
DISABLE
ENABLE This selects whether the material-cutting command is enabled or
disabled.
When set to [ENABLED], the material is cut automatically when the
computer sends a material-cutting command.
For more information, see "2-7 Ending Printing Operations -- Separat-
ing the Printed Portion."
— 0 to 100
mm
(In steps of
10 mm)
10 mm This makes the setting for the margin between pages.
When outputting a number of pages continuously, you can establish a
margin between the pages.
For more information, see "2-9 Other Functions -- Setting the Page
Margins." PAGE
MARGIN
— mm/INCH mm This selects millimeters or inches as the unit of measurement for the
width displayed on the top menu after setting up the material. When
inch display is used, values are displayed to the first digit to the right of
the decimal point. MENU UNIT
SYSTEM
REPORT
— — — This prints the current status of settings and other system information.
— — — This returns all menu settings to their original values when shipped
from the factory.
For more about the factory defaults for the various settings, see the
"Default value" entry for each menu setting in this section. FACTORY
DEFAULT
— — — INK LEFT This shows the amount of ink left after each of the ink cartridges has
been installed.
The fewer the markers (" "), the less ink is left.
* If a partially used ink cartridge is removed and reinstalled, or if a
partially used ink cartridge is installed, the cartridge is taken to be
unused, and the displayed amount of remaining ink is not true.
For more information, see "3-2 Remaining Ink."