beautypg.com

Operating instructions – Ryobi RGBV3100 User Manual

Page 11

background image

OPERATING INSTRUCTIONS

11

Use the blower for walls, overhangs and screens
(Fig. 17).

Fig. 17

OPERATING AS A VACUUM

1. Start engine. See Starting/Stopping Instructions.

2. Set the blower/vacuum mode change-over lever to

the down position (Vacuum Mode) (Fig. 18).

NOTE: Never use the unit with the lever halfway

in between either position.

3. Place the shoulder harness over your head, onto

your shoulder, and adjust it properly. See Installing
and Adjusting the Shoulder Harness
.

Hold the vacuum, tilting the blower/vacuum tube slightly,
and use a sweeping action to collect light debris
(Fig. 19). Small leaves and twigs will flow into the
vacuum bag and be mulched as they pass through the
fan housing, allowing the vacuum bag to hold more
debris.

Change-over lever

Fig. 19

Fig. 18

Vacuum

Mode

Blower

Mode

CLEARING A BLOCKED TUBE / IMPELLER

1. Put the Ignition Switch in the OFF position [O]

(Fig. 10) and wait for the impeller to stop rotating.

2. Disconnect the spark plug wire to prevent the unit

from starting.

3. Remove the blower/vacuum tube and the vacuum

bag.

4. Carefully remove material blocking the tube or

impeller. Inspect the blades to assure no damage
has occurred. Rotate the impeller blades by hand to
assure the blockage is completely cleared.

5. Reinstall the vacuum bag and blower/vacuum tube.

6. Reconnect the spark plug wire.

EMPTY THE VACUUM BAG

1. While pressing the latching tabs on both sides of the

vacuum bag tube, pull the vacuum bag off the unit
(Fig. 20).

2. Detach the vacuum bag from the vacuum bag hook.

3. Unzip the bag and empty the contents into a

garbage bag or container.

4. Turn the bag inside out after initial emptying and

vigorously shake out dust and debris.

5. Zip the bag closed and reinstall vacuum bag.

Fig. 20

Latching tabs