Ryobi RY09800 - Manual

RYOBI ART WORK
Art Part No. : 988000331 Rev. 00
Where Used : 988000331
Refer to Drawings for Dimensions.
Material: 60lb. Stock Paper.
Color: Lift-off Bright Pink.
FRONT
1
ENGINE STARTING PROCEDURE
988000331
10-11-10 (REV:01)
Depress the STOP switch to
the stop position “O”.
To Stop:
For any questions about operating or maintaining your product, call the Ryobi Help Line !
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual.
Go to www.ryobitools.com and register your new tool on-line.
CALL
1-800-860-4050
www.ry
obitools
.com
®
50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with
1 gallon of fresh gasoline in separate gas
container. SHAKE. Pour into fuel tank.
Allow engine to run for 10 seconds, then set the choke lever to the
RUN position.
Set the choke lever to " FULL CHOKE " position.
2
3
4
5
6
x10
1 GALLON
GAS
2.6
oz.
8
WARNING: This Engine Starting Procedure is not a substitute for reading
the operator’s manual. To reduce the risk of injury, user must read and under-
stand operator’s manual before using this product.
2
3
4
8
RUN
HALF
FULL
?
5
6
7
1
Pull starter grip sharply until engine attemps to run. Do not pull
starter grip more than 4 times.
2
3
4
8
RUN
HALF
FULL
?
5 SET to
6
7
1
Set the choke lever to the " HALF CHOKE " position.
PRIME x10
2
3
4
8
RUN
HAL F
FULL
?
5 SET to
6 7
BP 30
1
Lock cruise control.
7 Pull the starter grip and rope until the engine runs. Do not pull
starter grip more than 6 times.
NOTE: If engine does not not start, return to the FULL CHOKE
position and repeat the steps that follow.
1
2
3
6
8
7
5
4
Slowly press the primer bulb 10 times.
NOTE: After the 10th press, fuel should be visible in the primer bulb. If it is not, continue
to press the primer until you see fuel in the bulb.