Ryobi RY09701 User Manual
Engine starting procedure, Front, Press

RYOBI ART WORK
Art Part No. : 987000499 Rev. 000
Where Used : 987000499
Refer to Drawings for Dimensions.
Material: 60lb. Stock Paper.
Color: Lift-off Bright Pink.
FRONT
1
ENGINE STARTING PROCEDURE
987000499
4-28-09 (REV:01)
Note: When starting the blower for the first time or
when the battery voltage is low, it may be necessary to
manually start the blower.
PRESS
ignition switch.
PRESS and HOLD switch until
engine stops
To Stop:
For any questions about operating or maintaining your product, call the Ryobi Help Line !
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual.
Go to www.ryobitools.com and register your new tool on-line.
CALL
1-800-860-4050
www.ry
obitool
s.com
®
50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with
1 gallon of fresh gasoline in separate gas
container. SHAKE. Pour into fuel tank.
PRIME
press the PRIMER BULB 7 times.
DO NOT engage the THROTTLE until engine starts and runs.
SET
START lever to " START " position.
1 GALLON
GAS
2
3
4
5
6
Push the throttle to run.
x7
2.6
oz.
1
2
3
5
6
7
7
Place battery pack in the
blower.
The battery pack for this tool
has been shipped in a low charge condition to prevent possible problems.
Therefore, you should charge overnight prior to use.
4
WARNING:
This Engine Starting Procedure is not a substitute for reading
the operator’s manual. To reduce the risk of injury, user must read and under-
stand operator’s manual before using this product.