beautypg.com

Installatio, Receiving equipment, General specifications – Raypak RAYTHERM 0135B User Manual

Page 5

background image

RECEIVING EQUIPMENT

On receipt of your equipment, visually check for exter-

nal damage to the carton. If the carton is damaged, it

is suggested that a note be made on the Bill of Lading

when signing for the equipment.

Remove the boiler from the carton, and if it is dam-

aged, report the damage to the carrier immediately. Be

sure that you receive the number of packages indicat-

ed on the Bill of Lading. Claims for shortages and

damages must be filed with carrier by consignee.

Purchased parts are subject to replacement only

under the manufacturer's warranty. Debits for defec-

tive replacement parts will not be accepted and

defective parts will be replaced in kind only per our

standard warranties.

When ordering parts, you must specify Model and

Serial Number of the boiler. When ordering under war-

ranty conditions, you must also specify date of

installation.

Raypak recommends that this manual be reviewed

thoroughly before installing the boiler. If there are

any questions which this manual does not answer,

please contact your local Raypak representative.

GENERAL

SPECIFICATIONS

Raytherm hydronic boilers are design certified and

tested under the requirements of the latest edition of

the American National Standard, ANSI Z21.13/CSA

4.9. Each boiler has been constructed and pressure

tested in accordance with the requirements of Section

IV of the American Society of Mechanical Engineers

Code, and factory fire tested.

These boilers are designed for indoor installation with

a built-in drafthood, and a built-in sub-base for com-

bustible flooring. Models are available with standing

pilot, or with an intermittent ignition device (IID).

These boilers are equipped with the following compo-

nents: water circulation pump, pressure relief valve,

temperature/pressure gauge, adjustable high limit

switch, drain valve, fast response temperature sensor,

40 VA transformer, pump relay, vent thermal switch,

flame roll-out switch, and redundant combination gas

valve. Two-stage gas valve (50% firing on first stage)

is standard on models H-0090, H-0135 and H-0180.

The automatic ignition models and some standing pilot

models are provided with a plug-in connector that is

compatible with the Honeywell D80D vent damper.

Similar type vent dampers made by other manufactur-

ers, and design certified by a nationally-recognized

testing agency, under the ANSI Z21.66 standard, may

also be used.

Follow the installation instructions furnished with the

vent damper package. The plug-in connector can also

be used with power venters. Refer to the specific

installation instructions supplied by the power vent

manufacturer.

5

This manual is related to the following products: