RAD Data comm ARC-101 - Manual (Page 36)

Chapter 4. Software Management ARC-101 Installation & Operation Manual
4-2 Configuration Window
4.3 Screen Explanations
Each of the screens shown below is followed by a detailed explanation of the
parameters and options appearing in the screen.
•
The acceptable value range for each parameter, where applicable, is
shown in parentheses – "( )".
•
The default value for each parameter, where applicable, appears in the
screens.
4.4 General Information Window
To view general information about the ARC-101, such as software/hardware
versions, basic configuration and self-test results, select option 1 from the
main menu.
GENERAL INFORMATION
Software Version: 0.0
Hardware Version: 0.0
ATM Rate Converter Configuration:
Self-Test ended successfully
E1 STM-1
over to over
UTP/COAX FIBER
4.5 Configuration Window
Default configuration parameters can be changed via the Configuration
window. To enter the Configuration window, select oprtion 2 in the main
menu. The Configuration screen is divided into 6 submenus/commands:
System Parameters, Left Module parameters, Right Module parameters,
ASCII Terminal Configuration parameters, Set Default Parameters and Save
Changes. Note that some parameters are general while some depend on the
module type.
To Set a
Parameter:
•
Select the item number which corresponds to the parameter that you
want to view/configure.