RAD Data comm ARC-101 - Manual (Page 19)

ARC-101 Installation & Operation Manual Chapter 2. Installation
Cable Connections 2-3
Installation of
Two Units Rack adapter components for installing two units include two short side
brackets (for rack mounting) and two flat rails (for fastening the two units
together)
Figure 2-2 Installation of Two Units
To install two units follow these instructions:
1. Place two units side by side. On the top of each unit are four grooves.
The grooves should line up when the units are placed side by side.
2. Place a flat rail on each of the groves in the center of the two units.
3. Fasten the brackets to the units using the 8 screws provided.
4. Place the assembled units in the rack, and fasten the brackets to the side
rails of the rack, by means of the two screws situated on each side, as
shown in Figure 2.2 (not included in the kit).
2.5 Cable Connections
The ARC-101 has several connectors on its front panel (see Figure 2-3) for
ATM connection and connection to an ASCII terminal, and a power
connector on its rear panel.
°°
Figure 2-3 ARC-101 Front Panel
ATM Connection Connect the appropriate cables to the connectors in both modules .
Control Port
Connection The CONTROL port connector is an RS-232/V.24 RJ-45 connector for an
ASCII terminal (9600 baud).