Renesas SDI Emulator System M32100T-EZ-E - Manual (Page 40)

( 38 / 42 )
Chapter 7. Maintenance and Guarantee
7.1 Maintenance
If dust or dirt collects on any equipment of your emulation system, wipe it off with a dry soft cloth.
Do not use thinner or other solvents because these chemicals can cause the equipment's surface
coating to separate.
7.2 Guarantee
The product presented here has passed Renesas's product inspection. If your product becomes faulty
within 12 months after purchase while being used under good conditions by observing the
Precautions for Safety described in "Chapter 1. Precautions for Safety", Renesas will repair the fault
free-of-charge. (This provision does not apply to emulation pods leased to you.) When repair is
required, contact your local distributor.
7.3 Repair Provisions
If a fault in your equipment falls under one of the following categories, the fault will be corrected by
replacing the entire equipment instead of repairing, depending on the severity of fault:
• Faulty or broken mechanical section
• Flaw, separation, or rust in coated or plated section
• Flaw or crack in plastic section
• Fault or breakage caused by incorrect use or unauthorized repair or modification
• Heavily damaged electric circuits due to shorting of power supply, overvoltage, or overcurrent
• Crack in printed circuit board or burned-down patterns
• Broad range of fault making replacement less expensive than repairing
• Unlocatable or unidentifiable fault