Renesas SDI Emulator System M32100T-EZ-E - Manual (Page 18)

( 16 / 42 )
2.3 System Configuration of the M32100T-EZ-E
Because the M32100T-EZ-E uses a debug interface SDI (Scale Debug Interface) built in the MCU,
JTAG connection is available, which can directly control the MCU installed in the target board.
(1) JTAG Connection
The system configuration when using the M32100T-EZ-E by JTAG connection is shown below.
(1) Host machine (Personal computer)
(2) Emulator (M32100T-EZ-E)
(3) Emulator debugger (PD32RM)
(4) SDI MCU control interface cable
(5) USB interface cable
Figure 2.1 System configuration (JTAG connection)
Use the provided SDI interface cable to connect an SDI connector you prepare on the target board.
Because the emulator is connected to the target board using the SDI MCU control interface connector
(10-pin), the flexibility of designing around the MCU on the target board increases. It can be used
for debugging and evaluation on a test machine.
Directly installed on the target board, the target MCU will not cause problems on electrical equivalent
and poor connection.
Target board
Emulator debugger PD32RM
SDI MCU control interface cable
Emulator M32100T-EZ-E
Host machine (not included)
USB interface