Renesas SDI Emulator System M32100T-EZ-E - Manual (Page 10)

( 8 / 42 )
Caution for Abnormal Operation:
• If the emulator malfunctions because of interference like external noise, shut down the emulator
once and then reactivate it.
CAUTION
Cautions for Power Supply:
• Power is supplied from the host machine to this product via the USB interface cable.
• Switch on and off this product by the USB interface cable.
Cautions to Be Taken for Handling This Product:
• Use caution when handling the product. Be careful not to apply a mechanical shock.
• Do not touch the connector pins of the communications interface cable, emulator and target system.
Static electricity may damage the internal circuits.
• Do not pull this product by the cable connected to the emulator. The cable may cause a break.
• Do not use inch-size screws for this equipment. The screws used in this equipment are all ISO
(meter-size) type screws. When replacing screws, use same type screws as equipped before.
Cautions for Powering Up Sequence:
• When turning on power, activate the emulator first and then the target system.
• When turning off power, deactivate the target system first and then the emulator.
• Always wait for about 10 seconds after turning off the power before turning it on again.
Caution for Installation:
• This product is designed to be used being laid down. Do not use this product being set up.