Renesas SDI Emulator System M32100T-EZ-E - Manual (Page 25)

( 23 / 42 )
3.2 Connecting the Target System
The M32100T-EZ-E supports JTAG connection to connect to the target board.
To connect the emulator to the target board using the JTAG connection method, you should have the
SDI MCU control interface connector on the target board. Connect the M32100T-EZ-E connector
to the SDI interface connector on the target board using the provided cable.
(1) Connecting the SDI Interface Connector
Figure 3.3 shows how to connect the SDI MCU control interface connector on the target board to the
emulator, and the pin numbers of the SDI MCU control interface connector.
Figure 3.3 Connecting the SDI interface cable
(2) SDI MCU Control Interface Connector
Table 3.1 lists the pin assignments of the SDI MCU control interface connector. Figure 3.4 shows a
sample circuit of the SDI MCU control interface. The MCU signals' names of the connection target
are those of the M32170.
Table 3.1 SDI MCU control interface signal assignments
Emulator
SDI MCU control
interface
HIF3BA-10D-2.54R (cable side)
(Hirose Electric Co., Ltd.)
HIF3BA-10D-2.54R (cable side)
(Hirose Electric Co., Ltd.)
No. 1 pin (red)
Pin No.
1
2
3
4
5
6
7
8
9
10
Pin
TCLK
Vss
TDI
TDO
TMS
TRST
DBI
N.C.
Vcc
RST
Direction
Emulator to target
-
Emulator to target
Target to emulator
Emulator to target
Emulator to target
Emulator to target
-
Target to emulator
Emulator to target
Connection target
JTCK of MCU
GND (0 V)
JTDI of MCU
JTDO of MCU
JTMS of MCU
JTRST of MCU
JDBI of MCU
No connection
VCCE of MCU
System reset
Remarks
Clock frequency: 10 MHz/5 MHz
Totem-pole output on emulator side
Open collector output on emulator side
Target board