Renesas Pod probe for M16C/1N Group M301N2T-PRB - Manual (Page 28)

M301N2T-PRB User’s Manual 3. Usage
REJ10J0037-0100 Rev.1.00 Mar.16, 2005 Page 26 of 48
3.2 Turning On the Power
3.2.1 Checking Connections of the Emulator System
Before turning the power ON, check the connections of the PC4701, emulation pod, pod probe, converter board and user
system.
3.2.2 Turning ON/OFF the Power
(1) Turn on the power of the emulator and user system as simultaneously as possible.
(2) Turn off the power of the emulator and user system as simultaneously as possible.
(3) Do not leave either the emulator or user system powered on, because of leakage current the internal circuits may be
damaged.
(4) When turning on the power again after shutting off the power, wait about 10 seconds.
IMPORTANT
Notes on Power Supply:
The Vcc terminal of the emulator is connected to the user system to observe the voltage of the user
system. Therefore design your system so that the user system is powered by an external power supply.
The voltage of the user system should be within the MCU's specified range.
Do not change the voltage of the user system after turning on the power.