RCA Scenium PHD50300 - Manual (Page 55)

REFERENCE
Chapter 7 53
Other Information
*1 Only when using a graphic accelerator board that is capable of displaying 848 X 480.
*2 Aspect ratio is 5:4. This signal is converted to a 600 X 480 line signal.
*3 The picture is displayed in the original resolution.
*4 The aspect ratiois 5:4. This signal is converted to a 900 dot X by 768 line signal.
*5 Normally the RGB SELECT mode is set automatically. If the pictur e is not displayed properly, set the mode for the input signals listed in the table.
*6 To connect the monitor to a Macintosh computer , use a D-sub 15-pin monitor adaptor with your computer’s video port. If your computer has a D-sub
15-pin connector, use an RGB cable.
*7 Other Screen modes are also available.
Notes:
•
When the input signals comply with the resolution listed in the table above, the position and size of the pictur emay need to be adjusted.
• When a 1280 X 1024 line signal or a 1600 dot X 1200 line signal is input, the pictur e will be compressed.
• This monitor has a resolution of 1365 dot X 768 line. It is r ecommended that the input signal be XGA, wide XGA, or equivalent.
• Some signals are not accepted with digital input.
• The synch may be disturbed when a nonstandard signal other than those previously mentioned is input.
• If you are connecting a composite synch signal, use the HD ter minal.
* IBM is a registered trademark of International Business Machines Corporation of the United States.
* Macintosh is a registered trademark of Apple Computer, Inc. of the United States.