RCA Scenium PHD50300 - Manual (Page 18)

Connections and Setup
16 Chapter 1
How to Program the Remote
There are two ways to program the remote control: automatic code search and direct entry.
Component Buttons
These are the buttons you program to operate another
component.
MONITOR
ON•OFF
AUX DVD HD RCVR
VCR 1
VCR 2
Using Automatic Code Search
1. Turn on the component you want the remote to operate (VCR, HD
receiver, etc.)
2. Press and hold the component button that corresponds to the
component you want the remote to operate (VCR, HD receiver, etc.).
While you hold down the component button, press and hold
ON•OFF (when the red light on the remote turns on, release both
buttons).
Note: Automatic Code Search can’t be used with the AUX button.
3. Press PLAY (the red light on the remote starts flashing).
The remote is searching the first set of component codes (there are
several sets of codes). If the component you want to operate doesn’t
turn off automatically after 5 seconds, press PLAY again (the red light
starts flashing again as the remote searches through the next set of
codes).
Continue pressing PLAY until the component turns off.
NOTE: If the component doesn’t turn off after you’ve pressed the PLAY
button 20 times, the component can’t be programmed.
4. Press REVERSE and wait 2 seconds. Repeat this step until the
component turns back on.
5. To finish, press and hold the STOP button until the r ed light on the
remote turns off.