RCA Scenium PHD50300 - Manual (Page 35)

Chapter 6 33
The Menu System
Turning the Picture Back On
POWER
SAVER
Mode POWER/
STANDBY
indicator
Power Saver
Operating Status Description
On
Standby
Suspend
Off
Green
Yellow
Red
Red
Not activated
Activated
Activated
Activated
Horizontal and vertical
synchronizing signals are
present from the computer.
No horizontal synchronizing
signals are present from the
computer.
No vertical synchronizing signals
are present from the computer.
No horizontal and vertical
synchronizing signals are present
from the computer.
Picture already on.
Use the keyboard or mouse.
The picture reappears immediately.
Use the keyboard or mouse. The
picture reappears, but more slowly
than when in standby mode.
Use the keyboard or mouse. The
picture reappears, but more slowly
than when in either standby or
suspend mode.
POWER/STANDBY indicator
This is the FUNCTION menu with the POWER
SAVER option highlighted.
: ON
: 1
: ON
: 3
: ON
: 1
F U N C T I O N
SEL. ADJ.
DISPLAY
MENU ADJUST
POWER SAVER
GRAY LEVEL
FILM MODE
RGB3 ADJ.
SCREEN SAVER
RESET
RETURN
Setting the POWER SAVER for Computer Images
The POWER SAVER function can be used when the signal sour ce to the
monitor comes from a computer conforming to the VESA DPMS format.
This function automatically reduces the monitor’s power consumption if
no operation is performed for a certain amount of time. POWER SA
VER
can be turned on or off.
If the computer’s power isn’t turned on or if the computer and selector
tuner are not properly connected, POWER SAVER is set to OFF.
For instructions on using the computer’s power management function,
see your computer’s operating manual.
To turn the monitor’s POWER SAVER function on or off:
1. From the main menu, highlight and select FUNCTION. The
FUNCTION menu is displayed.
2. Highlight the POWER SAVER option.
3. Use the button to toggle the setting ON or OFF .
4. You can continue making adjustments in the FUNCTION menu,
return to the previous menu by pressing the GO BACK button or
press CLEAR to exit the menu system.
The POWER/STANDBY indicator shows the status of the POWER SA VER
function. See below for status and description.