Cleaning the everest printer, Clean the print head – Rimage EverestTM Printer User Manual

Page 30

Rimage Everest Printer

110632_L

Cleaning the Everest printer

Clean the print head

Before you begin:

Power off the printer.

1. Access

the

print head.

a. Press

the

two cover latches to release the side cover.

b. Lower

the

side cover.

c. Open

latch 1.

d. Remove

the

print ribbon carrier. For specific instructions, refer to page 20.

2. Clean

the

print head.

Caution! Wipe the print head from
one end to the other. Do not stop
wiping in the middle of the print
head.

Caution! Do not scratch the print
head. The white area in the picture
shows the area to clean.

a. Apply

isopropyl alcohol to the sponge swab.

b. Use

the

sponge swab to wipe across the print head from one end to the other.

c. Repeat as needed until the print head is clean of dust and debris.

d. Use

the

sponge swab to remove any waxy buildup from the roller below the print head.

Latch 1

Printhead

Wipe
direction

3. Prepare the printer for use.

a. Install

the

print ribbon carrier.

b. Close

all

latches.

c. Close

the

side cover.

d. Power on the printer. The printer is ready.