Rimage EverestTM Printer User Manual

Page 27

Maintain the Everest printer

110632_L

3. Install the new print ribbon.

a. Remove

the

new

ribbon

from the packaging.

b. Install

the

supply roll end

of the print ribbon on the
top of the carrier.

c. Insert

the

large shaft in

the large opening and
press the small shaft into
place.

Note: The ribbon must
come over the tacky
roller.

d. Wrap the ribbon around the

guide rollers.

e. Install

the

take up roll.

Large
opening

Small
shaft

Tacky roller

Supply
roll

f. Rotate

the

take up roll so the

ribbon is aligned and lies flat.

Tip: You may need to lift
the ribbon up from the
tacky roller to straighten it.

d a

nced to the take up

roll.

Note: If you installe
monocolor ribbon,
advance the ribbon so the
ink portion of the ribbon is
adva

4. Reassemble

the

printer.

Guide rollers

Pull handle

Supply roll

Take up roll

a. Slide

the

carrier into the printer.

b. Close

latch 1.

c. Close

the

side cover.

5. Power on the printer. The printer is ready.