RCA T13208 - Manual (Page 36)

34 Chapter 3
Using the TV/VCR’s Menu System
Additional Setup Features in the Menu
1. Press MENU to display the TV/VCR MAIN MENU.
2. Press 5 to select the SETUP menu.
Now you are ready to select an item from the menu to setup.
TV/VCR MAIN MENU
1 Screen
2 Time
3 Timer Recordings
4 Parental Controls
5 Setup
0 Exit
SETUP
1 Auto Channel Search
2 Add/Remove Channels
3 Set Auto Repeat
4 Auto Play: ON
5 Signal Type: CABLE
0 Exit
TV/VCR MAIN MENU
1 Screen
2 Time
3 Timer Recordings
4 Parental Controls
5 Setup
0 Exit
SETUP
1 Auto Channel Search
2 Add/Remove Channels
3 Set Auto Repeat
4 Auto Play: ON
5 Signal Type: CABLE
0 Exit
AUTO REPEAT
Set the length of time you
want the tape to play in a
repeating loop
Loop from 0:00 to 2:55
(h:mm)
Press MENU to exit
Auto Repeat Feature This feature tells the TV/VCR to play a tape (or part of
a tape) continuously. The TV/VCR will automatically rewind the tape, or a
selected portion of the tape, and play it repeatedly.
1. Using REW, FF, or PLAY, go to the place on the tape that you want to be
the beginning of the section that automatically repeats. Reset the time
counter to 0:00:00 by pressing DISPLAY, then CLEAR.
2. Using FF or PLAY, go to the place on the tape that you want to be the end
of the section that plays continuously. Remember the numbers on the time
counter. (2:55 is the end time for Auto Repeat in the example to the left.)
3. Press MENU to display the TV/VCR MAIN MENU.
4. Press 5 to display the SETUP menu.
5. Press 3 to display the AUTO REPEAT menu.
6. Using the number buttons, enter the amount of time you want the tape to
repeat (the number from Step 2). In the example at right, the section that
the TV/VCR will automatically repeat is 2:55—two hours, 55 minutes long.
To Cancel Auto Repeat
Press MENU, then 5, then 3, and then CLEAR.
Auto Play This feature allows the TV/VCR to automatically start playing a
tape when it is inserted. (The safety tab on the tape must be removed).
1. Press MENU to display the TV/VCR MAIN MENU.
2. Press 5 to display the SETUP menu.
3. Press 5 to change the Auto Play setting.
The Auto Play feature is set to On at the factory.
• Select On if you want a tape with its safety tab removed to start playing
automatically.
• Select Off if you do not want a tape with its safety tab removed to start
playing automatically.