RCA T13208 - Manual (Page 15)

Chapter 1 13
Connections & Setup
SKIP SPEED
OFF
REW PLAY FF
REC STOP PAUSE
DISPLAY SLEEP
MUTE PREV
1 2 3
4 5 6
7 8 9
0
TRACK F.ADV
CLEAR MENU RESET
-
TV VCR
+
CHAN
V
O
L
CHAN
V
O
L
SE
A R C H
The Buttons on the Remote Control
Your backlit remote has a light button ( ) that glows in the dark. Press this
button to light the CH ^/v and VOL buttons. The remote buttons remain lit
when they are pressed within a few seconds of each other. If a button is not
pressed within approximately seven seconds, the light turns off to conserve
battery power.
0-9 (Number buttons) Enter channel numbers and time settings directly
through the remote control.
To enter a two-digit channel, press the two digits. To enter a three-digit channel,
press and hold the first digit for two seconds until two dashes appear to the
right of the number, then add the second two. Example: to tune to channel 123,
press and hold 1 for two seconds, press 2, then press 3.
CH (up and down) buttons Scan up or down through stored channels. Press
once to change the channel up or down; press and hold to continue changing
channels.
CLEAR Removes any menu or display from the screen and returns you to
TV viewing.
DISPLAY Displays TV/VCR’s current status. Displays time counter when a tape
is inserted. Press again to remove display.
F. ADV (Frame Advance) Advances the tape one frame at a time when the
tape is in PAUSE mode. Also fast forwards the tape through a commercial when
a tape is playing.
FF (Fast Forward) Fast forwards the tape when the TV/VCR is stopped. Also
searches the picture in forward motion during playback.
MENU Displays the TV/VCR’s Main menu.
MUTE Lowers the TV/VCR volume to its minimum level. Press again to restore
volume.
OFF Turns the TV/VCR off.
PAUSE Pauses the tape during playback. Also pauses the tape during
recording to prevent recording of unwanted scenes.
PLAY Plays a tape.
PREV (Previous channel) Switches between the last two channels selected.
REC (Record) Starts TV/VCR recording. Used for express recording.
RESET Resets video functions to factory settings. Also used to reset time for
wake-up timer and alarm.
REW (Rewind) Rewinds the tape when the TV/VCR is stopped. Also searches
the picture in reverse during playback.