Ricoh Caplio RR30 - Manual (Page 151)

151
Appendix
G. Error Messages
If an error message is displayed on the LCD Monitor, follow the procedures below.
Error Message Countermeasure Page
INSERT CARD A card is not loaded. Insert a card. (see p.13)
SET DATE The date is not set. Set the date. (see p.12)
FILE NUMBER OVER LIMIT The file number limit has been exceeded. Please use another
card, or delete unwanted files. (see p.13,
82)
UNMATCHED FILE A file that cannot be played back was selected. —
INSUFFICCIENT MEMORY. CONTINUE? Because there is not sufficient capacity on the card, all the files
cannot be copied. Use another card. (see p.89)
PROTECTED You are trying to delete a protected file. (see p.85)
WRITE-PROTECTED The card is "Locked (write-protection)". Unlock the card. (see p.13)
PRINT SETTINGS CANNOT BE SET FOR
THIS FILE. This file (movies and other) cannot be selected for printing. —
INSUFFICIENT MEMORY Files cannot be stored. Make sure there is enough free space,
or delete files. (see p.82)
The image print number limit has been exceeded. Select an
image and set the number to 0. (see p.90)
FORMAT INTERNAL MEMORY It is necessary to format internal memory. (see p.95)
FORMAT CARD The card is not formatted. Format the card. (see p.94)
CARD ERROR Please reformat. If, after doing so, the error message still
appears, the card may be faulty. Do not use the card. —
WRITE TO CARD Writing file to memory. Wait until writing finishes. —
NO FILE There are no files that can be played back. —
CANNOT RECORD The Number of remaining shots is 0. Switch to another card or
internal memory. —
If the countermeasures above do not remedy the problem, please contact the Ricoh Service Center, or the
store where you purchased your camera.