Ricoh 1075 - Manual (Page 146)

Troubleshooting
132
6
Changing the Paper Size
Preparation
Be sure to select the paper size
with User Tools. Otherwise, mis-
feeds might occur.
⇒ p.79 “Tray
Paper Size: (Tray 2,3)”
Important
❒ If you wish to change the paper
size set in the paper tray 1 or the
optional large capacity tray (LCT),
contact your service representa-
tive.
Reference
For details about paper sizes, and
types see
⇒ p.177 “Copy Paper”.
Changing the Paper Size in
Tray 2 or 3
AAAA
Make sure the paper tray is not
being used. Then fully pull out
the paper tray.
Remove the paper in the tray.
BBBB
Press the lock button, and then
adjust the side fences and back
fence to the new paper size while
pushing the release lever.
CCCC
Square the paper and load it in
the paper tray, and then press the
lock button.
Important
❒ Confirm that the top of the stack
is not higher than the limit mark
inside the tray.
❒ Align the right edge of the copy
paper stack to the right edge of
the tray.
Note
❒ Shuffle the paper before loading
it in the tray.
❒ Straighten curled or warped pa-
per before loading it in the tray.
MartiniC1_GBzen2_FM.book Page 132 Friday, April 19, 2002 2:18 PM