Menus, autodial (for kp-12/dkp-12 only) – RTS Digital Matrix s Keypanels DKP-8 User Manual
Page 32
Menu Mode
26
Menus, Autodial (for KP-12/DKP-12 Only)
NOTE: This menu is used to store autodial numbers. To assign a key that dials a specific autodial number, see page 27. To use
stored autodial numbers with an all-purpose phone key see page 14.
Store autodial numbers as follows:
1.
All phone keys (including autodial or redial keys) must be OFF.
2.
When you select AUTODIAL, the call waiting window will display DIAL NUM.
3.
If your phone system requires you to enter a digit to request an outside line, enter that digit first. Some phone systems may
also require a brief pause after the request for an outside line. If this is the case, enter *99 after the first digit to create a
pause.
4.
Finish dialing the telephone number.
5.
When finished dialing, tap the SELECT control.
The call waiting window will then display TAP 0-9.
6.
Tap a single key (0 through 9) to assign the telephone number to autodial number 0 through 9.
7.
After an autodial number has been assigned, the call waiting window will again display DIAL NUM.
8.
Repeat steps 3 through 6 to store additional autodial numbers.
9.
Press and hold the SELECT control for two seconds to return to the top-level menu when you are finished entering
autodial numbers.
Table1.
Keypanel Menus in Menu Mode
AUTODIAL
KEY ASGN
KEY OPT
SERVICE
AUTODIAL
BTN LOCK
DIMMER
AUTOFUNC
CHIME
FOOT SW
CLEAR
CLR OPT
KEY TYPE
COPY
COPY
LOCK
LISTS
GROUP 1
MIC CTRL
ICOM
a
a. ICOM is only available for trunked intercom systems.
GROUP 2
MIC COMP
PL
GROUP 3
MIC GAIN
IFB
GROUP 4
MOD ASGN
IFSL
LATCHING
MUTE LVL
ISO
SOLO
OPTO ISO
b
b. LOCAL I/O and OPTO-ISO are available only with the optional GPI module installed (KP-12 only).
P-P
OUT CTRL
RLY
RESET
SPCL
SAVE CFG
UPL
SET ADDR
PHONE
SIDETONE
REDIAL
TALLY
TEST PNL
TONE
USM