Ricoh feeder - Manual (Page 75)

Loading paper
69
5
Loading Paper into the Large Capacity Tray (LCT)
The following procedure explains loading paper into the large capacity tray
(LCT). The LCT is identified as Tray 4, Tray 5, and Tray 6.
Important
❒ Various sizes of paper can be loaded in Tray 4 and Tray 5 by adjusting the po-
sitions of side fence and end fence.
❒ If you want to change the paper size of Tray 6, contact your service representative.
❒ Check the paper's edges are aligned at the left side.
❒ Do not stack paper over the limit mark.
A
Carefully pull out the paper tray until it stops.
B
Load paper into the paper tray by pushing it against to the left side of the
paper tray.
Load the paper print side up.
C
Carefully slide the paper tray fully in.
Note
❒ The tray can hold up to 1,100 sheets in Tray 4 and 5, and 2,800 sheets in Tray 6.
Reference
p.75 “Changing the Paper Size”
p.84 “Changing to a Size that is Not Automatically Detected”
ANQ006S
ANQ007S