Ricoh feeder - Manual (Page 27)

When a Message Appears
21
2
Duplex is not
available with
this paper size.
A paper size not available
in Duplex mode has been
selected. The following paper sizes are available
for Duplex mode: A3L, B4L, A4KL,
B5KL, A5KL, B6L, A6L,
12”×18”L, 11”×17”L, Legal
(8
1 /
2
”×11”)L, Letter (8 1 /
2
”×11”)KL,
Half Letter (5 1 /
2
”×8 1 /
2
”)KL, Execu-
tive (7 1 /
4
”×10 1 /
2
”)KL, F/GL
(8”×13”)L, Foolscap (8”×13”)L, Folio
(8
1 /
4
”×13”)L, 11”×15”L, 11”×14”L,
10”×14”L, 8 1 /
4
”×14”L, 8”×10”L,
8KL, 16KKL. Select one of these sizes.
Maximum number of
sets is nn.
(A figure is placed at n.)
The number of copies ex-
ceeds the maximum copy
quantity. You can change the maximum copy
quantity. See “Max. Number of Sets”,
General Settings Guide.
File being stored
exceeded max.
number of pages
per file. Copying
will be stopped.
The scanned originals
have too many pages to
store as one document. Press [Exit], and then store again with
an appropriate number of pages.
Magazine or Book-
let mode is not
available due to
mixed image mode.
You selected the Maga-
zine or Booklet function
for originals scanned us-
ing different functions,
such as copy and printer. Make sure originals for the Magazine
or Booklet function are scanned using
the same function.
Orig. is being
scanned by another
function. Please
wait.
Document Server or
Scanner function is in
use. To cancel the job in process, press [Exit],
and then press the {Document Server} or
{Scanner} key. Next, press the {Stop}
key. When the message “
The Clear
/ Stop key was pressed. Are
you sure you want to stop
scanning? ” appears, press [Cancel].
You do not have
the privileges to
use this function.
This user code is not al-
lowed to use the function
selected. Contact the administrator.
You do not have
the privileges to
use this function.
This user code is not al-
lowed to use the function
selected. If the message continues to be dis-
played and you cannot switch the
screen, press the {Energy Saver} key.
Confirm that the display goes off, and
then press the {Energy Saver} key again.
The display will return to the user code
entry display. When printing under the
copier or printer function, press the
{Energy Saver} key only after printing
has finished.
Message Cause Solution