Ricoh feeder - Manual (Page 74)

Adding paper, Toner and Staples
68
5
Loading Paper into Tray 2 and 3
The following procedure explains how to load paper into Tray 2 and 3.
Important
❒ Various sizes of paper can be loaded in Tray 2 and 3 by adjusting the positions
of side fence and end fence.
❒ Check the paper edges are aligned at the right side.
❒ Do not stack paper over the limit mark.
A
Carefully pull out the paper tray until it stops.
B
Square the paper and load it print side down.
C
Carefully slide the paper tray fully in.
Note
❒ If you load a paper size that is not selected automatically, you will need to
specify the paper size with the control panel. Following paper sizes that
are not selected automatically.
❒ The tray can hold up to 550 sheets.
Reference
p.75 “Changing the Paper Size”
p.84 “Changing to a Size that is Not Automatically Detected”
ANQ004S
ANQ005S