Seatalk, Seatalk2, Nmea 0183 – Raymarine VolvoPenta IPS Autopilot System DPU User Manual
Page 11: Connector block
11
SeaTalk
Using the appropriate cable, connect the SeaTalk terminal on the DPU to one of
the SeaTalk terminals on the S3G Autopilot. You will need to cut off the molded
plug and strip the cable as described above.
Note:
Note that the terminals are color coded to match the cable.
SeaTalk
2
Connect the red and black wires of the SHORT SeaTalk
2
cables to the red and black
terminals on the DPU. Ensure the remaining wires are suitably cut back and
insulated. Plug the other end into the SECOND terminal of a 5 way SeaTalk
2
connector block.
NMEA 0183
Connect the NMEA 0183 terminal on the DPU to the NMEA 1 terminal on the S3G
course computer. Ensure that the following connectivity is achieved:
SeaTalk
2
Connector Block
SeaTalk
NMEA 0183
D8037-2
NMEA 2000
Yellow
grounding cable
RF ground
1 2 3 4 5
DPU
to Volvo Penta
Autopilot
Interface Unit
S3G Course
Computer Terminals
SeaTalk
2
CAUTION
DO
NOT
CONNECT
TO
NMEA2000 BUS
87054_3.book Page 11 Tuesday, July 18, 2006 8:49 AM