Runco Video Xtreme VX-6000d - Manual (Page 31)

Runco VX-6000d Owner’s Operating Manual 19
PRE
L
IMINAR
Y
3.1
Remote Control
Battery Installation To install batteries in the remote control:
1. Remove the battery cover from
the back of the remote control.
2. Insert the batteries included
with the remote control. Ensure
that the polarities correctly
match the
and markings
inside the battery compartment.
3. Replace the battery cover.
With the touch-screen
remote: After a few seconds,
the remote starts up
automatically and an
Introduction screen appears.
The remote control beeps twice to indicate that it has started up successfully.
Notes on Remote Control
Operation The remote control can be used to control the VX-6000d within the ranges shown in
Figure 3-1.
Figure 3-1. Available Range of the Remote Control
3. Installation
1. Do not mix an old battery with a new one or different types of
batteries.
2. If you will not use the remote control for a long time, remove the
batteries to avoid damage from battery leakage.
Touch-Screen Remote Standard DHD Remote
Note
Approx.
7m / 23ft
Approx.
30m / 100ft