Radio Shack PRO-95 - Manual (Page 83)

Re
se
ttin
g
/In
itia
lizin
g
th
e
Sca
n
n
e
r
83
RESETTING/
INITIALIZING THE
SCANNER
If the scanner's display locks up or
does not work properly after you
connect a power source, you
might need to reset or initialize it.
!
R
ESETTING THE
S
CANNER
1. Turn off the scanner, then turn
it on again.
2. Insert a pointed object, such
as a straightened paper clip,
into the reset opening on the
side of the scanner. Then
gently press and release the
reset button inside the
opening.
Pressing the reset button does not
clear the scanner's memory.
I
NITIALIZING THE
S CANNER
1. Turn off the scanner, then turn
it on again. Welcome To Dual
Trunking appears. !
2. Press 0 then 1 while Welcome
To Dual Trunking appears.
Initializing Please Wait. appears
for about 2 seconds.
Do not turn off the scanner until
the initialization is complete. When
the initialization is complete
M000
appears on the top line of the
display.
Bank 0 Ch 00 appears on
the bottom line.
! IMPORTANT
!
Resetting/
Initializing the
Scanner
•
If you have
problems with the
scanner, first try
to reset it to retain
all memory. If that
does not work,
you can initialize
the scanner.
• You can save the
information in
your scanner’s
memory into your
computer or
another scanner
before trying to
initialize it. See
“Transferring
Data to and from
Another Scanner
or a PC” on
Page 15.
Initializing the
Scanner
This procedure
clears all information
you stored in the
scanner's memory.
Initialize the scanner
only when you are
sure the scanner is
not working properly.