Radio Shack PRO-95 - Manual (Page 27)

Op
er
ati
o
n
27
sure to get a current copy. Also
see the supplied Trunking Guide.
Follow these steps to store
frequencies into channels.
Ô
1. Press MANUAL , enter the
bank (0–9) and channel
number (00–99) where you
want to store a frequency,
then press
MANUAL again. M
and the bank and channel
number appear at the upper
left corner of the display (for
example:
M000 ).
• Press FUNC . Then press
or . The bank
number moves in the
direction of the arrow
pressed.
• Press FUNC . Then hold
down or . The bank
number moves con-
tinuously in the assigned
direction.
• Press . The channel
number moves upward one
by one. Or, press
. The
channel number moves
downward one by one.
2. Press PGM . M changes to P .
3. Use the number keys and
. / DELAY to enter the fre-
Ô
NOTE
Ô
• If you are storing
frequencies for an
EDACS system,
you must store
them in order, with
the first frequency
in channel 1 for
the current bank.
For example, if
you want to store
frequencies of
150.0100,
150.0200,
150.0300, and
150.0400 MHz,
you must store
them in Channels
1, 2, 3, and 4
respectively.
• When
M
is on the
display, you can
also select your
desired bank and
channel number
with the FUNC
and arrow keys.