Radio Shack PRO-95 - Manual (Page 59)

Tr
unk
in
g
59
1. Press PGM then TRUNK to
enter the ID program mode.
2. Press FUNC and press (or
hold) or to select the
bank.
3. Press MODE and select MOT .
4. Press FUNC then 2 . The
display indicates Base freq.: on
the first line, 406.0000 on the
second line, Offset: 380 on the
third line and Step: 25.0kHz on
the bottom line.
5. While B in Base blinks, if
necessary, press the desired
Base frequency with the
number keys and press
ENTER . Confirm the entry. If it
is incorrect, press the number
keys again to set the base
frequency. After you confirm
the input, press
ENTER again.
6. While O in Offset blinks, if
necessary, enter the offset
number and press
ENTER .
Confirm the entry. If it is
incorrect, then press the
number keys again to set the
frequency. After you confirm
the input, press
ENTER again.
7. While S in Step blinks,
repeatedly press or to
select the step number, 25.0 ,
50.0 or 12.5 kHz, then press
ENTER .
8. Press PGM to enter the
program mode. Store the
trunking IDs into the sub-bank
in the same bank.