Radio Shack PRO-95 - Manual (Page 62)

Tr
unki
n
g
62
5. Press ENTER for each entry. If
you make a mistake, press CL
and enter the correct size
code.
Ô
6. Press SCAN to start scanning.
T ALK G ROUP ID S
There are 10 talk group ID banks
and each ID bank has 5 sub-
banks. Each sub-bank has 20 ID
locations. You can program up to
100 talk group IDs in each bank,
so you can program up to 1,000
talk group IDs in 10 banks. When
the scanner stops on a
transmission in the Motorola, or
EDACS mode, it checks to see if
the ID has been stored. In the
closed mode, the scanner only
stops on the transmission and
displays its text tag if you have
stored and not locked out the ID.
In the open mode, the scanner
always stops on a transmission,
but it displays the ID's text tag if
you have stored the ID.
S
TORING
T
ALK
G
ROUP
ID
S
To store a talk group ID, press
TRUNK when the scanner stops on
a voice channel transmission or
when a talk group ID is indicated
in the manual mode. The bottom
line indicates where the ID was
stored as
ID save X—XX and then
changes to ID#XXXX .
The first X in ID save X—XX is the
sub-bank number ( 0—4 ) in the
bank. XX is the number of IDs from
( 00—19 ) in each sub-bank.
Ô
NOTE
Ô
• The default setting
of the bank is for
Motorola Type II.
However, if you
set Type I and you
want to return to
Type II, enter 15
at Step 5.
• To confirm the
input, repeat
Steps 1–5 and
press ENTER.
Each time you
press ENTER, you
confirm the size
code. If you find
an error, press CL
and begin again at
Step 1.