Renesas Compact Emulator M30620T-CPE - Manual (Page 44)

( 44 / 52 )
5.3 When the Operation of the Emulator is Abnormal
Self-check is a function to check the memory etc. mounted in the emulator. Self-check is executed
when the emulator starts up, and detailed check is executed by following the procedure below.
For this self-check, be sure to disconnect the target system.
(1) Self-check Procedure in the Self-check Mode
Figure 5.2 Self-check procedure
(1) Within 2 seconds of activating power to the
emulator, press the RESET switch.
(2) Target status LEDs repeat blinking
simultaneously.
(3) Press the system reset switch again after
checking target status LEDs blink.
(4) Target status LEDs repeat blinking in
succession.
One or more target status LEDs repeat blinking
according to the error type.
For starting up the emulator after self-check, shut
off the power of the emulator and reactivate it.
About
30 seconds
[When self-checks terminated normally]
LED display
ON Blinking OFF
[When error detected]
POWER CLOCK RESET RUN
LED2 LED3 LED4 LED5
POWER CLOCK RESET RUN
LED2 LED3 LED4 LED5
POWER CLOCK RESET RUN
LED2 LED3 LED4 LED5
POWER CLOCK RESET RUN
LED2 LED3 LED4 LED5
POWER CLOCK RESET RUN
LED2 LED3 LED4 LED5