Renesas Compact Emulator M30620T-CPE - Manual (Page 18)

( 18 / 52 )
(3) System reset switch
By pressing the system reset switch, you can initialize the emulator system. Table 2.3 shows the
functions of the system reset switch depending on the state of emulator.
Table 2.3 Functions of system reset switch
State of Emulator
Initializes the emulator and waits for commands from the
emulator debugger.
Stops the user's program, initializes the emulator, and
waits for commands from the emulator debugger.
Function
When the user's program is halted
When the user's program is executed
CAUTION
Note on System Reset Switch:
• After pressing the system reset switch, reboot the emulator debugger PD30M.
Otherwise the display of emulator debugger and the actual value (in the emulator)
may not match.
• When the emulator debugger does not start up normally even after rebooting, turn
off the emulator and then turn on again.