Radio Shack 43-3857 - Manual (Page 16)

Memory Dial
ing
16
If You Make a Mistake while Entering
a Name
Use /TONE/< or #/ > to move the cursor to the
incorrect character, press CH/DELETE to erase up to
the wrong entry. Then enter the correct character. To
delete all characters, press and hold
CH/DELETE .
For example, to enter John;
Ô
1. Pick up the handset. Press MEM .
2. Enter a number or press VOL or VOL to
select a memory location number.
3. Press MEM or REMOTE/SELECT .
4. Press MEM or REMOTE/SELECT. (When there is
information already stored in the selected
memory location,
Edit MemoryXX is
displayed. See “Editing a Stored Name and/or
Phone Number” on page 17.)
5. Press 5 once.
6. Press 6 six times.
7. Press 4 five times.
8. Press 6 five times.
9. When finished, press MEM or REMOTE/SELECT .
To continue to store the telephone number, proceed
to step 7 under “Storing Phone Numbers and
Names” on page 14.
M
AKING
C
ALLS WITH
M
EMORY
D
IALING
Memory Dialing from Standby Mode
1. Press MEM . The handset displays your
programmed memory locations.
Ô
NOTE
Ô
If the next character uses
the same number key, you
must press
#/ > to move the
cursor over. Otherwise the
next time you press the
number key, it changes the
character that was
previously set.
43-3857.book Page 16 Wednesday, February 18, 2004 12:40 PM